Mallinckrodt NPB-190 Instrukcja Operatora Pobierz pdf (Strona 20)

Setup

3. Plug the male connector end of the power cord into a

properly grounded AC outlet.

4. Verify that the AC Power Indicator is lit. If it is not, ensure

that the supply voltage selector switch matches your AC

voltage source. If the indicator still does not light, contact

qualified service personnel, your local Mallinckrodt

representative, or the Mallinckrodt’s Technical Services

Department.

WARNING: In the USA, do not connect the monitor to an

electrical outlet controlled by a wall switch because the

monitor may be accidentally turned off.

5. Select a Nellcor sensor appropriate for the patient to be

monitored (see the Sensors and Accessories section of this

manual for sensor selection information).

WARNING: Do not use an extension cable with the NPB-295

monitor (other than the MC-10 or SCP-10 sensor cable). Use

of another sensor extension cable will have an adverse effect

on performance. Do not attach to the sensor port any cable

that is intended for computer use.

6. Plug the sensor into the MC-10 or SCP-10 sensor cable, and

secure the sensor in place by lowering the plastic sensor lock

over the sensor connector until it clicks into place (refer to

the MC-10 or SCP-10 directions for use).

7. Plug the MC-10 or SCP-10 cable into the sensor port located

on the front of the NPB-295.

LANGUAGE SELECTION

The languages available for display on the screen are English,

French, German, Dutch, Portuguese, Spanish, and Italian. The

NPB-295 is shipped with the factory default English language

displayed.

To select the appropriate language after the unit is powered on,

press the SETUP softkey, then the NEXT softkey, then the

LANG softkey. Use the Adjust Up and Adjust Down Buttons to

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 86 87

Brak uwag

Mallinckrodt NPB-190 Instrukcja Operatora Strona 20