Mallinckrodt NPB-190 Instrukcja Operatora Pobierz pdf (Strona 47)

Start-Up and Use

Alarm Volume

To view the current volume of the audible alarm, press and hold

the ALARM SILENCE Button for more than 3 seconds. The

current volume level is indicated in the Pulse Rate Display as a

value from 1 (lowest) to 10 (highest). A tone at the displayed

level sounds.

To adjust the volume, press and hold the ALARM SILENCE

Button until VOL is displayed. Continue pressing the ALARM

SILENCE Button and press the ADJUST UP or ADJUST

DOWN Button to change the setting. The volume cannot be set

to zero.

Alarm Silence Duration

Alarms can be silenced for a preset period called the audible

alarm silence duration. To view the current setting, press and

hold the ALARM SILENCE Button for less than 3 seconds. To

adjust the setting, press and hold the ALARM SILENCE Button

(for less than 3 seconds) and use the ADJUST UP or ADJUST

DOWN Buttons to increase or decrease the value. Possible

values are 30, 60, 90, or 120 seconds, or OFF. (The OFF

selection is discussed later in this section.)

The audible alarm silence duration begins when the ALARM

SILENCE Button is pressed.

Subsequently, if any alarm condition (other than a low battery

alarm) occurs while the alarm is silenced, the alarm will not

sound until the alarm silence duration period expires. Operating

the monitor on battery power during a low battery alarm

condition will cause a low battery alarm to sound, even if the

duration time has not elapsed.

If the ALARM SILENCE Button is pressed during the alarm

silence duration, the alarm silence duration is ended and the

audible alarms are re-enabled.

Visual indications of an alarm condition cannot be turned off.

For example, if the %SpO

2 SatSeconds upper alarm limit is

exceeded, the alarm can be silenced for the alarm silence

duration, but the %SpO

2 value will continue to flash.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 109 110

Brak uwag

Mallinckrodt NPB-190 Instrukcja Operatora Strona 47